Modules for Elevator Repair | WORLD electronics

Elevator Modules & Miscellaneous Elevator Components

Elevator Modules & Miscellaneous Elevator Components

Button Tone Module

Ready for field installation! Provides audible beep upon completion of call entry.

7501.9067 – 125 VDC
7501.9068 – 48 VDC
7501.9069 – 24 VDC

2 Button Tone Modules

Used in hall stations to satisfy audible call registration acknowledgement requirements. This module will provide an audible beep every time the button is depressed.

7501.9093 – Works on 24 – 31 VDC
7501.9094 – Works on 45 – 55 VDC
7501.9095 – Works on 110 – 135 VDC

8 Button Tone Modules

Used in car stations to satisfy audible call registration acknowledgement requirements. Each module will handle a maximum of 8 buttons and can be used in combination.

7501.9096 – Works on 24 – 31 VDC
7501.9097 – Works on 45 – 55 VDC
7501.9098 – Works on 110 – 135 VDC

Two Stroke Gong Module

7501.9007 – 125 VAC/DC 3 wire hookup. Indicates Up direction on arrival at landing by ringing once. Down direction by ringing twice. Chime not included. Use one per hall station.

Two Stroke Machine Room Gong

7501.9008 – Indicates Up direction on arrival at landing by ringing once. Down direction by ringing twice. Length of 1st chime and off delay between chimes are adjustable. Hook-up simple for either new or retrofit application. Chime not included. Only one per car.

Multi Lane Stepper Mother Board

7501.9090 – 4 Lane Stepper with AC or DC inputs. Handles up to 32 landings. Available in 12, 24, 48, 110V AC/DC.

Multi Lane Stepper Relay Board

7501.9091 – For use with 7501.9090. 8 Landings per board.

Universal Relay Board

7502.9008 – Need to add a relay and keep it neat?!! This general purpose relay board may be your answer! It’s customized to your request. Available in +5VDC, +12VDC, +24VDC, +48VDC, +120VDC and 120VAC. Capable of holding up to 8 relays Mix and match voltages! Quick and easy to install or remove!

Edgewipes

7504.9001 – Used for removal of organic materials and/or corrosion, etc. from card edge connectors of circuit boards. Leaves surface clean, conductive, low resistive. Does not remove gold, solder or copper plating.